One should measure here with a universal meter. To determine that the signal of the ‘suspected’ unit will show at the correct PLC reference.To be able to identify if the PLC is still active and that there are no communication errors with the I/O or other coupled PLC’s.The maintenance engineer should therefore be capable of executing the following actions: This is necessary, because designers are not always able to design their programs to register every possible fault and the potential cause. These faults can be investigated via the programming terminal and the signal status can be presented dynamically. For instance a defective sensor, a badly working cylinder etc. Problems are most likely to occur with the installation itself and this is reflected in the PLC. The maintenance engineers should be capable of making small changes to the program. Programming and documenting the program is of less importance. ![]() ![]() With regards to PLC’s and programming terminals, the maintenance engineer needs to be able to access specific parts of the program and to examine the I/O status. ![]() One needs to have sufficient knowledge of the equipment, coupled with knowledge of the installation to be able to diagnose the problem and then solve the problem. This course recognises that maintenance personnel cannot build up a profound technical knowledge of all the equipment to be maintained. Maintenance services are often confronted with equipment from several manufacturers.
0 Comments
Leave a Reply. |